OMG77309 SI_PSD_22_TR-600 Datasheet Update FOR_OFFICE_USE

1. Technical datasheet Description The 3M ™ Versaflo ™ Powered Air Turbo TR-600 is a belt - mounted air purifying device. It can be combined with an approved headtop or facepiece to form a power-assisted system for respiratory protection against particles, nuisance odours (where applicable) and gases and vapours. A range of approved breathing tubes are available depending on which headtop or facepiece is selected. • Three user selectable flow rates • Controlled airflow delivers steady flow as battery discharges or filter loads with particulates • Display shows battery charge status and particulate loading status during use • No user calibration of the turbo is required • Electronic audible, visual and vibratory alarm in case of low battery and/or low air flow • Six filter options available: • P • P plus nuisance level* organic vapours and acid gas which also offers protection against Hydrogen Fluoride up to 10 x Occupational Exposure Limit • A1P • A1B1E1P • A2P • A2B2E2K1Hg • Lightweight lithium ion battery with LED to indicate charge status • Two belt options: • Easy-clean belt • High durability belt • Suitable for shower decontamination (IP54) when using filter cover and temporary submersion (IP67) when fitted with cleaning plugs Breathing tube options Headtop/facepiece Breathing tube 3M ™ Versaflo ™ S-Series Hoods and Headcovers 3M ™ Versaflo ™ M-Series Faceshields and Helmets 3M ™ Speedglas ™ 9100FX Air, 9100Air and 9100MP Welding Headtops BT-20S/L, BT-30 * or BT-40 3M ™ Full Facepiece Respirators 6000 Series 3M ™ Full Facepiece Respirators 7907S Series 3M ™ Half Facepiece Respirators 7500 Series BT-63 or BT-64 3M ™ Vision ™ Full Facepiece Respirator FM4 3M ™ Promask ™ Full Facepiece Respirator FM3 BT-54 *Note: BT-30 is not approved for use with 3M ™ Versaflo ™ Helmets M-400 Series and 3M ™ Versaflo ™ Powered Air Turbo TR-600 Standards and approvals The TR-600 Powered Air Turbo has been tested and approved to the following standards: • EN 12941:1998+A2:2008 with approved headtops • EN 12942:1998+A2:2008 with approved facepieces The TR - 600 also meets the following requirements: • Dust protection and protection against spraying water from all directions to EN60529 IP 54 • Dust tight and temporary submersion to 1m to EN 60529 IP 67 when fitted with cleaning and storage plugs The Certificate and Declaration of Conformity are available at the following website www.3M.com/Respiratory/certs and www.3M.com/Welding/certs Note: This product also complies with the European EMC Directive 2014/30/EU. 3M ™ Versaflo ™ Powered Air Turbo TR-600

2. Applications The TR-600 Powered Air Turbo, when used as part of an approved system with appropriate filters, provides protection against: • Particles e.g. fine dusts, mists and metal fume • Nuisance odour* levels (below the Occupational Exposure Limits) of organic vapours • Nuisance odour* levels (below the Occupational Exposure Limits) of acid gases and up to 10 x Occupational Exposure Limits of Hydrogen Fluoride • Organic gases and vapours (with boiling point > 65°C) • Inorganic gases • Acid gases • Ammonia • Mercury vapour *Nuisance level refers to concentrations below the Occupational Exposure Limits The TR-600, when used with an appropriate 3M headtop and filters, can be used in various applications including: • Agriculture • Chemical industry • Construction and building renovation • Demolition • Food and beverage • Medical and healthcare • Metalworking • Pharmaceutical manufacturing • Pulp and paper processing • Smelting and foundries • Surface preparation, paint spraying and coating • Woodworking Limitations The TR-600 Powered Air Turbo should not be used in the following conditions: • Asbestos removal • In atmospheres containing less than 19.5% oxygen • Confined spaces (lack of ventilation) • When the risk is considered to be Immediately Dangerous for Life or Health (IDLH) • Where the contaminant concentration is above the Occupational Exposure Limit defined for the headtop or facepiece used (see headtop user instruction or relevant breathing tube user instructions for information on systems comprising facepieces) 3M ™ Versaflo ™ Powered Air Turbo TR-600 Materials Component Material Turbo body Polycarbonate/acrylonitrile butadiene styrene blend Filter cover Polyamide Battery casing Polycarbonate/acrylonitrile butadiene styrene blend Easy clean belt Ethylene vinyl acetate foam, polyamide webbing High durability belt Ethylene vinyl acetate foam, leather belt Product range The TR-600 Powered Air Turbo is available to buy as: • TR-602E Turbo Unit (includes TR-971 Airflow Indicator and TR-662 Spark Arrestor x 2) • TR-619UK/E Starter Kit includes the TR-602E Turbo Unit, TR-632 High Capacity Battery, TR-641UK/E Single Station Battery Charger Kit, TR-971 Airflow Indicator, TR-6310E (A2P) Filter, TR-6300FC Filter Cover, TR-6600 Prefilter (x 10), TR-662 Spark Arrestor, TR-627 Easy Clean Belt and BT-30 Length Adjusting Breathing Tube • TR-600E-HIK Ready-Pak includes the M-307 Helmet, TR-602E Turbo Unit , TR-632 High Capacity Battery, TR-641E Single Station Battery Charger Kit, TR-971 Airflow Indicator, TR-6310E (A2P) Filter, TR-6300FC Filter Cover, TR-6600 Prefilter (x 2), TR-662 Spark Arrestor (x 2), TR-626 High Durability Belt, BT-30 Length Adjusting Breathing Tube BT-926 Flame Resistant Breathing Tube Cover and TR-653 Cleaning and Storage Kit • TR-600E-HKL Ready-Pak includes the S-133L Headcover, TR-602E Turbo Unit , TR-632 High Capacity Battery, TR-641E Single Station Battery Charger Kit, TR-971 Airlfow Indicator, TR-6710E (P) Filter, TR-6700FC Filter Cover, TR-6600 Prefilter (x2), TR-627 Easy Clean Belt, BT-30 Length Adjusting Breathing Tube, BT-922 Disposable Breathing Tube Cover and TR-653 Cleaning and Storage Kit • TR-600E-ECK Ready-Pak includes the S-433L Hood, TR-602E Turbo Unit , TR-632 High Capacity Battery, TR-641E Single Station Battery Charger Kit, TR-971 Airlfow Indicator, TR-6710E (P) Filter, TR-6700FC Filter Cover, TR-6600 Prefilter (x 2), TR-627 Easy Clean Belt, BT-30 Length Adjusting Breathing Tube, BT-922 Disposable Breathing Tube Cover and TR-653 Cleaning and Storage Kit

4. Spare parts and accessories Part number Description TR-630 Standard battery TR-632 High capacity battery TR-640 Battery charger cradle TR-641E/UK Single station battery charger kit (Europe/UK) TR-644E/UK 4-station battery charger kit (Europe/UK) TR-626 High durability belt TR-627 Easy clean belt TR-627X Easy clean belt extender TR-6710E Particulate filter TR-6820E Particulate filter plus nuisance level organic gases and vapours below TLV (Occupational Exposure Limit), nuisance level acid gases below OEL and Hydrogen Fluoride gas up to 10 x OEL TR-6110E A1P – organic gases and vapours (bp > 65°C) and particulates TR-6130E A1B1E1P – organic gases and vapours (bp > 65°C), inorganic, acid gases and particulates TR-6310E A2P – organic gases and vapours (bp > 65°C) and particulates TR-6580E A2B2E2K1HgP – organic gases and vapours (bp > 65°C), inorganic, acid gases, ammonia, mercury vapour and particulates TR-6100FC Filter cover for TR-6100 Series Filters TR-6300FC Filter cover for TR-6300 Series Filters TR-6500FC Filter cover for TR-6500 Series Filters TR-6700FC Filter cover for TR-6700 Series Filters TR-6800FC Filter cover for TR-6800 Series Filters TR-6600 Pre-filter Part number Description TR-662 Spark arrestor TR-651 Filter latch assembly TR-653 Cleaning and storage kit (for TR-600 and TR-800 Powered Air Turbo) TR-654 Replacement seals (for TR-653 cleaning and storage kit) TR-971 Airflow indicator (for checking TR-600/ TR-800 Powered Air Turbo when used with headtops) TR-973 Airflow indicator (for checking TR-600/ TR-800 when used with facepieces) BPK-01 Backpack TR-655 Backpack adaptor TR-329 Braces BT-20 S/L * Lightweight breathing tube small/medium or medium/long) BT-30 * Self-adjusting breathing tube BT-40 * Heavy duty breathing tube BT-63 * Length-adjusting tight fitting breathing tube BT-64 * Heavy duty tight fitting breathing tube BT-54 * Heavy duty tight fitting breathing tube BT-922 Disposable breathing tube cover (for BT-20S/L, BT-30, BT-40 and BT-54) BT-926 High durability, flames resistant breathing tube cover (for BT-20S/L, BT-30, BT-40 and BT-54) BT-953 Cleaning and storage kit (for BT-63 and BT-64) BT-957 Storage plugs (for all BT-Series breathing tubes) * See breathing tube options table 3M ™ Versaflo ™ Powered Air Turbo TR-600 Personal Safety Division 3M Centre Cain Road, Bracknell Berkshire RG12 8HT www.3M.eu/safety Please recycle. Printed in the UK. © 3M 2020. 3M, Promask, Speedglas, Versaflo and Vision are trademarks of 3M Company. All rights reserved. OMG77309 Important notice The use of the 3M product described within this document assumes that the user has previous experience of this type of product and that it will be used by a competent professional. Before any use of this product it is recommended to complete some trials to validate the performance of the product within its expected application. All information and specification details contained within this document are inherent to this specific 3M product and would not be applied to other products or environment. Any action or usage of this product made in violation of this document is at the risk of the user. Compliance to the information and specification relative to the 3M product contained within this document does not exempt the user from compliance with additional guidelines (safety rules, procedures). Compliance to operational requirements especially in respect to the environment and usage of tools with this product must be observed. The 3M group (which cannot verify or control those elements) would not be held responsible for the consequences of any violation of these rules which remain external to its decision and control. Warranty conditions for 3M products are determined with the sales contract documents and with the mandatory and applicable clause, excluding any other warranty or compensation. Respiratory protection is only effective if it is correctly selected, fitted and worn throughout the time when the wearer is exposed to respiratory contaminants. 3M offers advice on the selection of products, and training in the correct fitting and usage. For more information on 3M products and services please contact 3M.

3. System classifications and protection factors The information in the table below depends on the headtop or facepiece used. Refer to specific datasheet for headtop or facepiece for more information. EN 12941:1998 + A2:2008 EN 12942:1998 + A2:2008 Classification TH2 TH3 TM2 TM3 NPF 50 500 200 2000 Note: The Nominal Protection Factor (NPF) is a number derived from the maximum percentage of total inward leakage permitted in relevant European Standards for a given class of respiratory protective device. This may not be the level of respiratory protection that can be realistically expected in the workplace by wearers. Many countries apply Assigned Protection Factors (APFs) for example UK and Germany. Employers may apply a value lower than the NPF/APF if deemed applicable. Please refer to EN 529:2005 and National workplace protection guidance for application of these numbers in the workplace. Please contact 3M for further information. Storage conditions -30ºC to +50ºC < 90%RH Operating temperature -10ºC to +55ºC 3M ™ Versaflo ™ Powered Air Turbo TR-600 Shelf life * 5 years from date of manufacture * The shelf life as defined above remains an indicative and maximum data, subject to many external and non controllable factors. It may never be interpreted as a warranty. Outlet flow characteristics Flow rate In combination with approved headtop In combination with approved facepiece MMDF 1 170 l/min 115 l/min Standard flow 185 l/min +/- 10 l/min 135 l/min +/- 10 l/min Medium flow 205 l/min +/- 10 l/min 150 l/min +/- 10 l/min High flow 2 225 l/min +/- 10 l/min 170 l/min +/- 10 l/min Note: 1 MMDF = Stated Manufacturer’s Minimum Design Flow (MMDF) 2 Systems incorporating certain filters must not be used with the Powered Air Turbos operating at high flow. These specific systems may display a low flow alarm immediately when used. The specific systems are: FM4 with TR-602E – TR-6310E/TR-6580E must not be used in high flow setting. Battery charge time Standard battery Less than 3.5 hours High capacity battery Less than 4.5 hours Battery duration (hours) – with approved headtops Standard flow Medium flow High flow All filters P filter All filters P filter All filters P filter TR-630 battery 6–12 10–12 5.5–11.5 9.5–11.5 4.5–9.5 8.5–9.5 TR-632 battery 9.5–19 15–19 8.5–15 14.5–15 7–14.5 13.5–14.5 Battery duration (hours) – with approved facepieces 3M ™ Full Facepiece Respirators 6000 Series 3M ™ Full Facepiece Respirators 7907S Series 3M ™ Half Facepiece Respirators 7500 Series 3M ™ Vision ™ Full Facepiece Respirator FM4 3M ™ Promask ™ Full Facepiece Respirator FM3 Standard Flow Medium Flow High Flow Standard Flow Medium Flow High Flow TR-630 battery 9–12 7–11 6–9 6–9 4–7 4–5.5 TR-632 battery 12–18 11–16 8–14 10–13 6.5–11 6–8.5 Note: Battery durations are with new battery and clean filter at 20°C