Pesticide Standards Posters

1. PESTICIDES STANDARDS, INCREASED PROTECTION FOR BETTER WORKER SAFETY Ansell, ® and TM are trademarks owned by Ansell Limited or one of its affiliates. © 2021 Ansell Limited. All rights reserved. Neither this document nor any other statement made herein by or on behalf of Ansell should be construed as a warranty of merchantability or that any Ansell product is fit for a particular purpose. Ansell assumes no responsibility for the suitability or adequacy of an end user’s selection of gloves for a specific application. EN ISO 27065: Updated Standard EN 18889: New Standard The standard consists of three levels C1, C2 and C3 with the latter being the highest protection level : The compliance results are as follows for each category: Chemical Protective Gloves Mechanical Protective Gloves G1 G2 GR Low chemical risk Higher chemical risk Re-entry activities only For contact with diluted pesticides For contact with diluted and concentrated pesticides For dry contact or partially dry pesticide residue Cumulative permeation of Diluted solution of Surrogate Test chemical During 1 hour → max. cumulative permeation = 10 μg/cm² of disperse yellow Cumulative permeation of Diluted solution of Surrogate Test chemical During 1 hour → max. cumulative permeation = 1 μg/cm² of disperse yellow Cumulative permeation of Diluted solution of Surrogate Test chemical During 1 hour → max. cumulative permeation = 1 μg/cm² of disperse yellow - Cumulative permeation of concentrated solution of Surrogate Test chemical During 15 minutes → max. cumulative permeation = 1 μg/cm² of disperse yellow - ISO 18889 G1 ISO 18889 G2 ISO 18889 GR Visit www.ansell.com/enresourcecenter to learn more about the protection standards for pesticides use. EN ISO 27065 C1 Level C1: - Suitable when potential risk is relatively low. - Not suitable for use with concentrated pesticide formulations. - Can be used as base protective clothing. Level C2: - Higher level of liquid penetration resistance than Level C1. - Not suitable for use with concentrated pesticide formulations. - Can be used as base protective clothing. Level C3: - Suitable when potential risk is determined to be high. - May cause heat build-up resulting in heat stress. - Suitable for use with concentrated and diluted pesticide formulations. Penetration ≤ 40% Penetration ≤ 5%,  ≥ 80% repellency Permeation, cumulative ≤ 1 μg/ cm 2 Penetration ≤ 40% (Full suit type 6 spray test) Permeation, cumulative ≤ 1 μg/ cm 2 MATERIAL LEVEL SEAM EN ISO 27065 C2 EN ISO 27065 C3 Chemical Hand Protection Chemical Body Protection